King Controls KD-2200 User Manual

Page 12

Advertising
background image

Page 10

INTERNAL WIRING

15. Choose your desired wiring configuration:

Wall Plate Amplifier with single off-air output

Fig. 10, Page 11

A/V Distribution Box with built-in Amplifier, single off-air output

Fig. 11, Page 12

A/V Distribution Box with built-in Amplifier, multiple off-air outputs

Fig. 12, Page 13

16. Inside the vehicle, make the connections as shown in the wiring diagrams, keeping in mind

the following important points:

a) The connection between the dome unit and the main satellite receiver must be a direct

connection thru the diplexer, with no other devices in between.

b) Power connection must be a non-shared circuit. Excessive current draw on the circuit

will cause the unit to operate improperly. Power and ground connections must be made
after all wiring is connected to the dome unit.

c) If fusing the circuit, the fuse must be rated at 7.5 amps.

d) Install the off-air combiner only if using the existing off-air antenna as well. If not using

the existing antenna, connect the diplexer “ ANT OUT” directly to TV, converter box,
off-air input of receiver, or off-air splitter.

e) HDTV receivers require HDMI or component video/audio cable connection to TV

(sold separately).

17. When installation is complete, go to Section 4, ANTENNA CONFIGURATION on page 15.

Note: Using multiple receivers is not recommended for multi-satellite services where automatic satellite switching is

desired.

Components and wiring supplied with the KD-2200/KD-3200 are shown in black.
Existing components and wiring or those sold separately are shown in gray.

Advertising
This manual is related to the following products: