Konica Minolta IP-011 - Manual (Page 10)

Introduction
viii IP-011 Printer Controller
■ System Requirements
● Windows
The following are required to print from the Windows*-compliant computers to the Printer Controller.
•
Computers on which Windows 95/98, WindowsNT 4.0 can run
•
CD-ROM drive (necessary to install the user software)
In case of using Windows 95/98
•
Microsoft Windows 95/98
•
32MB RAM or more
In case of using Windows NT 4.0
• Microsoft Windows NT 4.0 and NT Service Pack 3
•
32MB RAM or more
Parallel Port
The following are required to print to the Printer Controller by way of the parallel port.
•
Windows-compliant computers
•
Minimum RAM capacity suitable for computers (Refer to the section of each operation system
described above.)
•
IEEE 1284 parallel cable
One end of the cable is required to have an amphenol 36 pin male connector (connected to the
Printer Controller).