Konica Minolta IP-011 - Manual (Page 9)

Introduction
IP-011 Printer Controller vii
■ About Positioning of This Manual
This manual describes how to operate the Printer Controller Konica IP-011 when the Konica 7020 series copier is
used as a printer by connecting it to computers or your network.
An optional network board (KN-304) is required so as to use the Konica 7020 series copier as a
printer by connecting it to your network.
Refer to the "7020 series operating manual" and the "KN-304 operating manual" which are
attached to the Printer Engine (7020 series) on the printer side and the optional Network Board
(KN-304) respectively for their operations.
■ About Composition of This Manual
This manual is composed of the following five chapters and Appendix:
Chapter 1: Outline
Chapter 1 describes the Printer Controller' hardware and the outline of its functions, and briefly
explains how to connect the parallel ports of computers to the Printer Controller and the Printer
(7020 series).
Chapter 2: Setup
Chapter 2 describes how to install the user software which is supplied in the user software CD to
the Windows*-compliant computers. Installing the user software enables printing from each
application of the Windows*-compliant computers to the Printer (7020 series) by way of a network/
parallel port.
Chapter 3: Printer Driver
Chapter 3 describes the corresponding environment and various functions of the Printer Driver
installed to the Windows*-compliant computers.
Chapter 4: Operation Panel Setup
Chapter 4 describes the layout of the operation panel of the Printer (7020 series) and how to
operate and set functions on the operation panel.
Chapter 5: Status Monitor/Control Panel
Chapter 5 describes the layout of the status monitor and the control panel shown on the Windows*-
compliant computers and how to operate and set functions on the status monitor or the control
panel.
Appendix
Appendix describes error messages and trouble-shootings inherent in the Printer Controller and
product specifications and functions.