Konica Minolta IP-011 - Manual (Page 46)

Chapter 3 Printer Driver
3-8 IP-011 Printer Controller
■ Description of Printer Driver Functions (in the alphabetic order)
Functions (setting items) which can be set with the Printer Driver are summarized in the alphabetic order. These
settings can be set by using [Start]-[Settings]-[Printers]- [KONICA IP-011] property. The tabs in this section are
those in the [KONICA IP-011] property.
● Alphabetic Order
About
When [Setup] tab-[About] button is clicked,
version information of the Printer Driver is
shown.
Add Port
When the port you would like to connect to is
not shown on the list shown by clicking the [ ▼ ]
button beside the [Details] tab-[Print to the
following port] , click [Details] tab-[Add Port]
button to add the port.
When the [Add Port] button is clicked, the [Add
Port] dialog is shown.
The following settings are performed on the
[Add Port] dialog;
When [Network] is selected to set a path to a network printer, you can add a network printer to a port.
When [Others] is selected to select the type of a port to be added, you can add the port
selected from a list.
Alternate
When the following conditions are satisfied, you
can perform settings of the alternate printing by
using [Setup] tab-[Alternate].
•
When [None] is selected in the Finisher
settings, or when the Finisher is not
installed,
•
When [A4], [Letter] or [B5] is selected in
the paper settings,
•
When the same size of paper for both
portrait and landscape is set to the copier, (e.g.: A4/A4R,
and B5/B5R)
•
When Front/Back Cover are not set and,
•
When [Booklet] is not selected in the [Duplex].
When [On] is selected in the Alternate printing, every set of copies are output in a direction at
right angles to the previous set of copies.
A
3rd copy
2nd copy
1st copy
On Off
e.g.
2nd copy
1st copy