Konica Minolta IP-011 - Manual (Page 28)

Chapter 2 Setup
2-8 IP-011 Printer Controller
Installation by Using the “User Software CD”
Turn on the computer to start WindowsNT4.0.
. Log on as an administrator (or a user entitled to install the Power User, etc.).
. Set the “User Software CD” on the CD-ROM drive.
Double-click the [My Computer] icon of the desktop to open the [My Computer] win-
dow, and double-click the active CD icon (user software CD).
Opening from the start menu.
Right-click the [Start] button of the task bar to click [Explorer]. Then, you can select the CD icon
(user software CD) from [All Folder].
Double-click the [NT nozomi] folder to double-click [Setup.exe] in the folder.
The [Konica IP-011 Setup] screen will appear. Then, click the [Next] button.
The [Konica IP-011 Software License Agreement] screen will appear. Then, click the
[Yes] button.
To use the Konica IP-011 Printer Driver, you are required to agree to the license.
When you agree to the license, click the [Yes] button to proceed.
The [Type of Connection] screen will appear. Then, select [Local] and click the [Next]
button.
When the Konica 7020 series Copier (IP-011) is directly connected to a computer to which the
printer driver is to be installed, select [Local].
In case of selecting [Network]
When installing Konica IP-011 printer driver to win4.0 that does not conduct print service, select
[Network]. When the optional network board (KN-304) is used, refer to the user's manual of the
KN-304 to select the appropriate port.