Konica Minolta IP-011 - Manual (Page 34)

Chapter 2 Setup
2-14 IP-011 Printer Controller
[Image]-[Layout]: 1-Up, 2-Up, 4-Up, 8-Up and 9-Up
Specifies how many pages of documents are gathered on one piece of paper. The default
value, [1-Up(Default)], indicates that an one-page document is printed on one piece of paper.
[Image]-[Print Page Borders]: Default value (not printing: without a check mark)
Specifies whether borders are printed or not between documents when they are gathered on
one piece of paper.
[Image]-[Staple]: off, 1-Left, 1-Right, 2-Left, 2-Top and 2-Right
Specifies the number of staples to be used and their positions.
When [off] is selected, documents are not stapled.
The staple function is supported when the finisher is attached.
[Image]-[Duplex]: 1-Sided, 2-Sided Long Edge Binding, 2-Sided Short Edge Binding and Booklet
[1- Sided] prints only one side.
[2- Sided Long Edge Binding] prints both sides so that heads of both sides become upward
while [2-Sided Short Edge Binding] prints both sides so that the head of one side becomes
the bottom of the other side.
[Booklet] prints in consideration of making booklets.
[Output]-[Output Tray]: Printer's default, Tray 1, Tray 2, Tray 3 and Tray 4
Specifies the way to output.
When [Printer's default] is selected, the output tray specified on [Paper] of the control panel
will be used for output.
In order to specify [Tray 2], [Tray 3] and [Tray 4], it is required that a finisher is attached to the
Copier and that the [Finisher] option must be selected.
[Output]-[Alternate]: On and Off
This setting is available only when the finisher is not attached. The output direction of paper
is changed every set of copy.
[Output]-[Sorting]: Sort and Group
Specifies how to output the multiple pages and multiple copy jobs.
[Engine Display]:
Shows the external view of the copier system.
[About] button:
Shows information on the version of the printer driver.
[Default] button:
Returns to the default value.