KTM 690 ENDURO EU - Manual (Page 129)

MAINTENANCE WORK ON CHASSIS AND ENGINE
127
600616-10
– Stand the vehicle upright.
– Place a suitable container under the engine.
– Remove screw
 . Remove the radiator cap.
– Completely drain the coolant.
– Fit screw
 with a new seal and tighten it.
Specification
Plug, drain hole of water pump M10x1 15 Nm (11.1 lbf ft)
– Install the engine guard. ( P. 132)
9.69
Filling the cooling system
x
Warning
Danger of poisoning Coolants are poisonous and a health hazard.
– Avoid contact between coolants and skin, eyes and clothing. If fuel gets into your eyes, rinse immediately with water and con-
tact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor immediately.
Change clothes that have come into contact with coolants. Keep coolants out of the reach of children.
600618-10
– Stand the motorcycle on its side stand on a horizontal surface.
– Remove radiator cap
 .