KTM 690 ENDURO EU - Manual (Page 119)

MAINTENANCE WORK ON CHASSIS AND ENGINE
117
600612-10
– Pull bulb socket  out of the reflector.
– Pull parking light bulb
 out of the bulb socket.
– Check parts for damage and wear. Replace damaged or worn parts.
– Insert a new parking light bulb into the bulb socket.
Parking light (W2,1x9,5d) ( P. 158)
– Insert the bulb socket into the reflector.
– Insert the rubber cap.
– Refit the headlight mask with the headlight. (
P. 114)
9.60
Changing the flasher bulb
Note
Damage to reflector Keep the glass of the bulb free of grease.
– Clean the glass bulb with a clean cloth before mounting. Any grease on the glass will evaporate by the heat and be deposited on the
reflector.
100301-10
– Remove the screw on the rear of the flasher housing.
– Carefully swing the diffuser
 forwards and remove it.
– Lightly pinch the orange cap  at the holding points and remove it.
– Press the flasher bulb carefully into the holder, turn it about 30° counterclockwise and
remove it from the holder.
Info
Do not touch the reflector with your fingers and try to avoid contact with oil or
grease.
– Check parts for damage and wear. Replace damaged or worn parts.