Checking rear brake fluid level, P. 86), Maintenance work on chassis and engine – KTM 690 ENDURO EU User Manual
Page 88
MAINTENANCE WORK ON CHASSIS AND ENGINE
86
100257-10
– Remove screw connection
on foot brake cylinder
.
– To adjust the basic position of the foot brake pedal as needed, loosen nut
and turn
screw
accordingly.
Info
The range of adjustment is limited. The screw must be screwed into the footrest
bracket by at least four turns.
– Position foot brake cylinder
so that the foot brake pedal has the necessary free travel.
Hold screws
in place and tighten the nuts.
Specification
Nut, foot brake cylinder screw
M6
10 Nm (7.4 lbf ft)
– Check the free play of the foot brake lever. (
– Tighten nut
.
9.36
Checking rear brake fluid level
Warning
Danger of accidents Brake system failure.
– MINIf the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Have the brake system checked in an authorized KTM workshop, and do not ride any further.