Troubleshooting – KTM 450 SMR User Manual

Page 69

Advertising
background image

TROUBLESHOOTING

67

Faults

Possible cause

Measure

Engine has no idle.

Ignition system defective

ಥ

Have ignition system checked.

Engine does not speed up.

Carburetor running over because float
needle dirty or worn

ಥ

Have carburetor checked.

Loose carburetor jets

ಥ

Have carburetor checked.

Electronic ignition adjustment defective

ಥ

Have ignition system checked.

Engine has too little power.

Fuel feed interrupted

ಥ

Check tank vent.

ಥ

Clean fuel tap.

ಥ

Clean carburetor.

Air filter very dirty

ಥ

Clean the air filter. (

P. 59)

Exhaust system leaky, deformed or too lit-
tle glass fiber yarn filling in main silencer

ಥ

Check exhaust system for damage.

ಥ

Change glass fiber yarn filling of main
silencer. (

P. 58)

Valve clearance too little

ಥ

Have valve clearance adjusted.

Electronic ignition adjustment defective

ಥ

Have ignition system checked.

Engine stalls or is popping into the carbu-
retor

Lack of fuel

ಥ

Clean and check the fuel system and
carburetor.

Engine takes in bad air

ಥ

Check rubber sleeves and carburetor
for tightness.

Engine overheats.

Too little coolant in cooling system

ಥ

Check the cooling system for leakage.

ಥ

Check the coolant level. (

P. 55)

Too little air stream

ಥ

Switch off engine when standing.

Radiator fins very dirty

ಥ

Clean radiator fins.

Foam formation in cooling system

ಥ

Drain the coolant. (

P. 56)

ಥ

Refill the coolant. (

P. 56)

Bent radiator hose

ಥ

Replace the radiator hose.

High oil consumption

Engine vent hose bent

ಥ

Route the vent hose without bends or
replace it if necessary.

Engine oil level too high

ಥ

Check the engine oil level. (

P. 62)

Engine oil too thin (low viscosity)

ಥ

Change the engine oil and oil filter,
and clean the oil screen. (

P. 63)

Battery discharged

Battery is not charged by generator

ಥ

Check electrical system.

Advertising