Kenwood TH-K2E - Manual (Page 47)

33
1 Press [MENU].
2 Turn the Tuning control to select Menu No. 6
(SFT).
3 Press [MENU].
4 Turn the Tuning control to select “+” or “–”.
• To program a –7.6 MHz offset (TH-K4E only),
select “–7.6” instead.
5 Press [MENU] to store the setting or [PTT] to
cancel.
• “+” or “–” (or “ ”) appears above the frequency,
indicating which offset direction is selected.
If the offset transmission frequency falls outside the
allowable range, transmission is inhibited. In this
case, adjust the reception frequency so that the
transmission frequency is within the band limits.
Note: While using an odd-split memory channel or transmitting,
you cannot change the offset direction.
■ Selecting an Offset Frequency
To access a repeater which requires an odd-split
frequency pair, change the offset frequency from the
default which is used by most repeaters. The default
offset frequency on the 2 m band is 600 kHz (all
TH-K2 models); the default on the 70 cm band is
5.0 MHz (TH-K4AT) or 1.6 MHz (TH-K4E).