Kenwood TH-K2E - Manual (Page 91)

77
• When DTMF TX Hold is activated {page 77}, you do
not need to continuously press [PTT] to remain in
Transmission Mode. However, Transmission Mode is
retained for only 2 seconds after pressing a key, so if
the next key is not pressed within this time limit, the
transceiver stops transmitting.
DTMF TX Hold (TH-K2AT/ ET/ K4AT only)
This function causes the transceiver to remain in
Transmission Mode for 2 seconds after you release
each key. So, you can release [PTT] while sending the
DTMF tones.
1 Press [MENU] to enter Menu Mode.
2 Turn the Tuning control to select Menu No. 34
(DT.H).
3 Press [MENU] and turn the Tuning control to select
“ON”.
4 Press [MENU] to store the setting or [PTT] to cancel.
A
UTOMATIC
D
IALER
If you use the 10 dedicated memory channels to store
DTMF numbers, you do not need to remember a long
string of digits.
Storing a DTMF Number in Memory
1 Press [MENU] to enter Menu Mode.
2 Turn the Tuning control to select Menu No. 32
(DTMF.MR).
3 Press [MENU].
4 Turn the Tuning control to select your desired DTMF
memory channel number from 0 to 9.