Dcs code id scan – Kenwood TH-K2E User Manual
Page 89
75
DCS Code ID Scan
This function scans through all DCS codes to identify
the incoming DCS code on the received signal. You
may find this useful when you cannot recall the DCS
code that the other persons in your group are using.
1 Press [MENU] and turn the Tuning control to select
Menu No. 5 (DCS).
2 Press [MENU] (1 s) to start the DCS Code ID Scan
function.
•
While scanning, the decimal point between “DCS” and
the DCS code blinks.
•
To reverse the scan direction, turn the Tuning control.
•
To quit the function, press [PTT].
•
When a DCS code is identified, the identified DCS
code appears and blinks.
3 Press [MENU] to program the identified DCS code in
place of the current DCS code. Otherwise, press
[PTT] to exit the DCS Code ID Scan.
•
Turn the Tuning control while the identified DCS code
is blinking to resume scanning.
Note:
◆
Received signals are monitored through the speaker while
scanning is in progress.
◆
DCS Code ID Scan does not scan the code if a signal is not
detected.