Kathrein UFS 700sw - Manual (Page 23)

23
Connected equipment
Use the

buttons to select the type of system to which they are connected or the single-cable
system components fi tted (refer to the manuals, instructions and notes for the system and the system
components). Available options:
- User-defi ned
-
KATHREIN UAS 481 (single-cable feed system, max. four receivers)
- KATHREIN EXR 551 (single-cable switching matrix, max. four receivers)
- KATHREIN EXR 552 (single-cable switching matrix, max. two receivers)
- KATHREIN EXU 908 (single-cable matrix, max. eight receivers)
- EXR 4 subscribers (for future Kathrein single-cable switching matrices, max. four receivers)
- EXR 8 subscribers (for future Kathrein single-cable switching matrices, max. eight receivers)
Selection “user-defi ned”
Transmission channel
Use the

buttons to select a free available transmission channel.
Transmission frequency
Use the numeric pad to input the four-digit transmission frequency.
Secure channel with PIN
If your single-cable system allows the transmission frequency to be protected by inputting a PIN, this is
the menu where that can be done. No other receiver can then use that transmission frequency unless the
PIN is input.
Use the

buttons to select the setting “Yes”. A line with the text “Password PIN” is then displayed.
Press the

buttons to select this line. You can now use the numeric pad to input a PIN (0-255).
FIRST INSTALLATION: Single-cable system (Manual)
If one or more receivers are
already present on the system
and an additional receiver is to
be connected, you must assign
the new receiver a transmission
frequency that is not already in
use (otherwise the receivers will
interfere with each other).
Depending on the system to which
they are connected, a maximum
of four or eight receivers may be
connected to a single-cable system
(a twin receiver counts as two
receivers).
No frequency can be used by more than one receiver.
The receivers would interfere with each other.
You can fi
nd the necessary information (transmission frequencies) in the
documentation supplied with your system.