Kathrein UFS 700sw - Manual (Page 47)

47
Use the

buttons to switch to the selection fi eld “End” and use the

buttons or the numeric
pad to select the desired recording ending time.
When all settings have been made, press the button to save the recording settings. You can view the
recording in the Timer List view of the EPG (see item “Plan recording”).
SERIES RECORDING
Use the

buttons to select the recording mode “Series recording”.
In series recording the start and fi nish of recording are taken automatically by the receiver from the
EPG data. You can specify only a single value for the lead-in and run-on time to be sure to record the
complete programme even if transmission times may vary slightly. The setting of lead-in and run-on time
is done using the

buttons or the keypad.
When all settings have been made, press the button to save the recording settings. You can view the
recoding schedule in the Timer List view of the EPG (see item “Plan recording”).
Series recording depends on the EPG data being kept up to date at all times.
This depends on the receiver being automatically updated at 03:00 (see section
“Important Information - Switching off the receiver and updating the EPG”).
Updating is important because it enables the receiver to recognise for purposes
of recording any changes to scheduled transmission times of the series, provided
these were incorporated in the EPG data supplied by the channel providers in
advance of the latest EPG update.
EPG - ELECTRONIC PROGRAMME GUIDE