Kathrein UFS 700sw - Manual (Page 39)

39
EPG - ELECTRONIC PROGRAMME GUIDE
Selection options:
- (red) button Calls up the plan recording (display of all pre-programmed recordings)
-

button Jump the “Current” view forwards by 15 minutes
-
"
(yellow) button Call up a preview of the currently highlighted channel
-
#
(blue) button Call up the category selection (sorting the programmes by categories such as
movies, sport, series ...)
-
&
button (P+) jump forwards 24 hours in the EPG, (P-) jump backwards 24 hours in
the EPG (e.g. into “Current” and into “Preview”)
- button Selects the currently highlighted channel in all views. Pressing the button
or the

button again closes the EPG and the selected channel is shown
again on the TV screen
-

(red dot) button Adds a programme to the recording settings
-

button Search for a particular programme or programme content (input the search
expression using the numeric pad on the remote control, see also the section
“Operating instructions”, “Alphanumeric input”)
- button If present, shows further information on the selected programme.
Navigation within each view is always performed using the cursor buttons (
 
).
The

buttons allow you to select individual channels/programmes, and the

buttons allow
you to scroll from page to page of the currently selected list.
Pressing the

button or the

button exits the EPG again and returns to the TV picture.
You will see information on the current or next following programmes in the
EPG only if it is supplied by the channel provider. If no EPG data are available the
receiver, instead of showing information on the current programme, shows the
message “No data available!”.
“CURRENT” VIEW
The “Current” view can be called up at any time in EPG by pressing the
!
(green) button. This is then
automatically displayed every time the EPG is started (see screenshot “Calling up EPG”).
In the “Current” view you see all channels displayed in the order of the overall channel list. Provided that
EPG data has been supplied by the channel provider, the receiver shows for each channel the current
programme being shown, with start time, fi nish time, and progression bar.
You can use the cursor buttons (
 
) or the keypad buttons to select the desired channel and if