Kathrein UFS 700sw - Manual (Page 3)

3
IMPORTANT INFORMATION
SWITCHING OFF THE RECEIVER AND UPDATING THE EPG
By pressing the

button you can switch the receiver out of TV mode and into standby mode. Pressing any
of the numeric buttons returns it from standby mode into operating mode.
Every night at 03:00 the receiver automatically starts to update the EPG data. This updates the EPG data
for the fi rst 25 channels of the overall channel list. This update happens however only if the receiver is in
standby mode. If the receiver is completely switched off (at the mains) or if it is in operation, the update will
be delayed. The receiver will update the EPG data when it is next switched from operating mode into standby
mode. After updating the data, the receiver automatically switches back to standby. You can however by
pressing the

button break off the update before it is fi nished; the receiver then switches immediately into
standby mode.
REFERENCE NOTE ON AUDIO MPEG INC. AND S.I.SV.EL, S.P.A:
This device employs legally protected technologies which are protected by patents in the USA as well as by
intangible property laws in other countries.
Audio MPEG Inc. and Societa‘ Italiana per lo sviluppo dell‘elettronica, S.I.SV.EL, S.P.A, have granted
KATHREIN-Werke KG rights of use which are subject to certain restrictions. These restrictions must also be
observed by you as a customer.
According to these, this device is only to be used by end customers for private, non-commercial purposes
and for licensed content. Use for commercial purposes is not authorised. Utilisation of products or procedures
sold or used with this device are not comprehended. With reference to licensed technologies, application of
reversible procedures as well as dismantling of the device are both not permitted.
The channels available on the satellites and transponders are subject to continual change. If changes do
occur, the new channels have to be set in the receiver because the factory preset programming corresponds
to the status on the date of manufacture. The information for these settings can be found on the Internet or
in relevant magazines.
Your receiver was equipped in the factory with the latest software version at that time. We are, however,
constantly working on adapting the software to the wishes of our customers and to developments in
technology. The “Software Update” section provides more information on this aspect.
The information in this operating manual was correct at the time of going to press.
We reserve the right however to make changes at any time and without prior notice.
If new software is released for your receiver, and this affects the information in the operating manual
(e.g. changes to the menus and/or functions), if we believe it necessary we will make available a new
operating manual for download under “www.kathrein.de”.
Please keep the original packaging in case you need to return the product at any time!
If the product is not properly packed, the warranty claim is invalidated.
Make a note of the receiver's basic settings (these are set during the fi rst installation), so you can restore
them if necessary!
The term DiSEqC™ used in this operating manual is a registered trade mark of the European
Telecommunication Satellite Organisation (EUTELSAT).