Lanier 5622 AG - Manual (Page 20)

Connecting the Machine
7
1
Note
❒ Consult your network administrator before connecting the machine to a net-
work.
❒ Make sure to use a properly shielded and grounded cable (UTP, STP, Catego-
ry/Type5) for the connection to the host computer (and/or HUB) in order to
meet FCC and EMC Directive 89/336/EEC emission guidelines.
Connecting the Network Cable to the Network
Limitation
❒ The IEEE1394 Board and the Network Interface Board cannot be installed at
the same time.
AAAA
Turn off the main power switch.
BBBB
Loop the network cable twice. The loops should be about 10cm (4”) from
the end of the cable closest to the printer.
CCCC
Attach the ferrite core to the loops.
DDDD
Attach the network cable to the jack on the board.
EEEE
Connect the other end of the network cable to the network.
FFFF
Turn on the main power switch.
ZFFH210E
ZFFH030E
RussianC2-EN-sysF1_V4_FM.book Page 7 Thursday, August 23, 2001 11:34 AM