Removing, Installing, Serveraid-br10i – Lenovo RD210 User Manual
Page 80: Sas/sata, Controller
Note:
If
there
is
a
gap
between
the
DIMM
and
the
retaining
clips,
the
DIMM
has
not
been
correctly
inserted;
open
the
retaining
clips,
remove
the
DIMM,
and
then
reinsert
it.
11.
Reconnect
the
power
cord
and
any
cables
that
you
removed.
12.
Replace
the
cover
(see
13.
Turn
on
the
peripheral
devices
and
the
server.
Removing
and
installing
the
IBM
ServeRAID-BR10i
SAS/SATA
Controller
To
remove
and
install
the
IBM
ServeRAID-BR10i
SAS/SATA
Controller,
complete
the
steps
in
this
section.
Removing
the
IBM
ServeRAID-BR10i
SAS/SATA
Controller
To
remove
the
IBM
ServeRAID-BR10i
SAS/SATA
controller
from
the
system
board,
complete
the
following
steps:
1.
Read
the
safety
information
in
and
2.
Turn
off
the
server
and
peripheral
devices
and
disconnect
the
power
cords.
Note:
When
you
disconnect
the
power
source
from
the
server,
you
will
lose
the
ability
to
view
the
LEDs
because
the
LEDs
will
not
be
lit
with
the
power
source
removed.
Before
disconnecting
the
power
source,
make
a
note
of
which
LEDs
are
lit,
including
the
LEDs
that
are
lit
on
the
operation
information
panel,
the
EasyLED
panel,
and
LEDs
that
are
lit
inside
the
server
on
the
system
board;
then,
see
for
information
on
how
to
solve
the
problem.
3.
Remove
the
cover
(see
4.
Disconnect
the
signal
cables
that
are
attached
to
the
drive
backplane
from
the
connectors
on
the
controller.
5.
Grasp
the
SAS/SATA
controller
near
the
end
next
to
the
power-supply
cage
and
press
the
black
plastic
tab
(next
to
the
power
supply)
that
is
holding
the
controller
in
place
toward
the
power
supply.
6.
Pull
up
on
the
SAS/SATA
controller
until
the
RAID
riser
card
assembly
disengages
from
the
connector
on
the
system
board.
1
USB
embedded
connector
2
RAID
controller
connector
3
Riser
card
error
LED
4
SAS/SATA
RAID
riser
card
7.
Grasp
the
SAS/SATA
controller
and
pull
it
out
of
the
connector
on
the
RAID
riser
card
assembly.
64
ThinkServer
RD210
Types
3795,
3796,
3818,
and
3819:
Installation
and
User
Guide