Removing a cd/dvd cable, Removing, Cd/dvd – Lenovo RD210 User Manual

Page 113: Cable

Advertising
background image

CAUTION:

When

laser

products

(such

as

CD-ROMs,

DVD

drives,

fiber

optic

devices,

or

transmitters)

are

installed,

note

the

following:

v

Do

not

remove

the

covers.

Removing

the

covers

of

the

laser

product

could

result

in

exposure

to

hazardous

laser

radiation.

There

are

no

serviceable

parts

inside

the

device.

v

Use

of

controls

or

adjustments

or

performance

of

procedures

other

than

those

specified

herein

might

result

in

hazardous

radiation

exposure.

DANGER

Some

laser

products

contain

an

embedded

Class

3A

or

Class

3B

laser

diode.

Note

the

following.

Laser

radiation

when

open.

Do

not

stare

into

the

beam,

do

not

view

directly

with

optical

instruments,

and

avoid

direct

exposure

to

the

beam.

Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
Appareil A Laser de Classe 1

`

7.

Slide

the

drive

through

the

front

of

the

server.

8.

Touch

the

static-protective

package

that

contains

the

new

optical

drive

to

any

unpainted

metal

surface

on

the

server;

then,

remove

the

drive

from

the

package

and

place

it

on

a

static-protective

surface.

9.

Follow

the

instructions

that

come

with

the

drive

to

set

any

jumpers

or

switches.

10.

Attach

the

drive

retention

clip

that

you

removed

from

the

previous

drive

to

the

side

of

the

new

drive.

11.

Align

the

drive

in

the

drive

bay

and

slide

the

drive

into

the

CD/DVD

drive

bay

until

the

drive

clicks

into

place.

12.

Connect

the

drive

cable

to

the

system

board.

The

following

illustration

shows

the

cable

routing

for

the

CD/DVD

drive:

Note:

The

CD/DVD

cable

should

go

on

the

top

of

the

operation

information

panel

cable

(in

the

middle)

and

the

Video/USB

cable

(on

the

bottom)

when

all

three

cables

are

installed

in

the

server.

13.

Reconnect

the

power

cord

and

any

cables

that

you

removed.

14.

Turn

on

the

peripheral

devices

and

the

server.

Removing

a

CD/DVD

cable

To

remove

the

CD/DVD

cable,

complete

the

following

steps:

1.

Read

the

safety

information

in

“Safety”

on

page

vii

and

“Installation

guidelines”

on

page

39.

Chapter

5.

Installing

optional

devices

and

replacing

customer

replaceable

units

97

Advertising
This manual is related to the following products: