Lincoln Impinger Conveyor Oven Series 1000 User Manual
Page 76
Impinger I -–1000 Series Service Manual - International
76
THE FOLLOWING ITEMS ARE USED IN THE MODEL 1030, 1046, 1047
IMPINGER OVEN (EXPORT)
AIR PRESSURE SWITCHES - REPLACEMENT AND ADJUSTMENT
1.
Remove control panel top.
2.
Disconnect wires from switch making note of wire number and location for reinstallation.
3.
Remove air tube from switch assembly.
4.
Remove switch from wire hanger.
5.
Install new switch in reverse order, make sure air tube is not blocked miss-aligned. Adjust as needed.
To adjust the air pressure switch, remove snap on cover on the side of the switch to
expose adjusting screw. To increase sensitivity, turn screw counter clockwise; to
decrease sensitivity, turn screw clockwise. Check for proper line voltage switching from
N.C. to N.O. as the air pressure switch closes.
GAS VALVE - REPLACEMENT AND ADJUSTMENTS
1.
Remove control panel top and front cover.
2.
Disconnect the gas piping from the back of the unit.
3.
Remove the four (4) screws from the incoming nipple mounting bracket.
4.
Remove incoming nipple.
5.
Disconnect two (2) plugs, (1 ) 3 prong and (1 ) 4 prong - Note location.
6.
Disconnect pipe union just above gas valve and remove assembly.
7.
Reassemble in reverse order (check all pipe fittings for leaks). After assembled, check
for proper adjustment of gas pressure switch, 8.8 on dial for natural gas, 23 for L.P. Gas
and 4.5 for town gas.
8.
Check and adjust manifold pressure. Remove pressure tap located in gas piping above
the gas valve prior to the burner orifice and install manometer . Adjustment screw is
located on the front of the valve, remove plastic cap and adjust as needed: 3.5" W.C. for
Natural Gas and 10" W.C. for L.P.
9.
Check gas filter by removing cover plate (located on either side of valve). Remove four
(4) screws and slide filter out of valve housing and inspect. Reassemble in reverse
order and check for leaks around cover.
+
-
1 2
gnd
3
3
2
gnd
FILTER
COVER
PLATE
FILTER
COVER
PLATE
PRESSURE
CONTROLLER
ADJUSTMENT
MANIFOLD
PRESSURE
ADJUSTMENT
OUTPUT
ELECTRICAL
CONNECTOR
ELECTRICAL
CONNECTOR
TOP VIEW
SIDE VIEW