Linksys SLM248G4S (G5) - Manual (Page 21)

Chapter  Configuration Using the Web-based Utility
1 24/48-Port 10/100 + 4-Port Ggabt Reslent Clusterng Smart Swtch wth 2 Combo SFPs
Chapter :
Confguraton Usng the
Web-based Utlty
This chapter describes the features included in the
Web-based Utility. All features shown in this chapter,
unless specifically identified, are included in all Resilient
Clustering Smart Switches. Unique features for specific
Switches are noted.
NOTE: The web-based utility is optimized for
a screen resolution of 1024 x 768. Internet
Explorer version 5.5 or above is required.
To use the utility, open your web browser, enter
http://192.18.1.24 in the Address field, then press Enter.
Address Bar
NOTE: The default IP address is 192.18.1.24.
If you have changed the IP address or are using
DHCP to assign it, enter the new IP address
instead. The computer you use for configuration
should be on the same subnet as the Switch.
The Login screen appears. Enter admn in the Username
field and enter the password in the Password field. If this is
the first time you are using the utility, leave the Password
blank. Then press OK to log in. The Setup tab’s Summary
screen appears.
(After you have completed your first login, for security
purposes it is recommended that you set a password at
a later time. For detailed information on changing the
password, refer to section “Admin > User Authentication.”)
Login Screen
Each time you log in, the web-based utility first displays
the Setup tab’s Summary screen. To access another screen,
you first select the appropriate category from among
the 11 tabs that appear at the top of the screen: Setup,
Port Management, VLAN Management, Statstcs,
Securty, QoS, Spannng Tree, Multcast, SNMP, Admn,
and Logout. Then, select the desired screen from the list
directly below the tab names.
Setup
The Setup tab contains the Summary, Zoom, Network
Settings, Time, and Stack Management screens.
Setup > Summary
The Summary screen displays a summary of Switch
information. The settings shown cannot be modified
from the Summary screen; however, many of them can be
modified from the Setup tab’s Network Settings screen.
Setup > Summary
The Summary screen has two sections: Device Information
and System Information. These are described below.
Device Information
System Name Displays the name of the Switch, if one has
been entered on the Setup tab’s Network Settings screen.
IP Address The IP address assigned to the Switch. The
Switch’s default IP address is 192.18.1.24. This setting
can be configured from the Setup tab’s Network Settings
screen.
Subnet Mask The Subnet Mask assigned to the Switch.
The default is 2.2.2.0. This setting can be
configured from the Setup tab’s Network Settings screen.