Linksys SLM248G4S (G5) - Manual (Page 29)

Chapter  Configuration Using the Web-based Utility
2 24/48-Port 10/100 + 4-Port Ggabt Reslent Clusterng Smart Swtch wth 2 Combo SFPs
Acceptable Frame Type This specifies the type of frames
that the port will accept. If All (default) is selected, the port
will accept all frame types, including tagged or untagged
frames. If Tagged is selected, the port accepts only tagged
frames. When set to All, each untagged frame received is
assigned to the specific VLAN that matches the PVID.
PVID Use this field to select the VLAN ID that will be
assigned to untagged frames received on the port.
Valid IDs are 1 (default) to 409. VLAN 4094 is reserved
for internal use. VLAN 4095 is defined per standard and
industry practice as the Discard VLAN. Frames tagged for
the Discard VLAN are dropped.
Ingress Flterng Enables or disables Ingress filtering
on the port. Ingress filtering discards packets that do not
match port ingress rules. The default is Enabled.
LAG Displays the LAG, if any, to which the port belongs. A
port’s LAG settings override the VLAN port settings.
Click Save Changes to save your changes, or click Cancel
Changes to cancel.
VLAN Management > Port to VLAN
You use the Port to VLAN screen to add ports to a VLAN and
delete ports from a VLAN. When you add a port to a VLAN,
you also specify whether the port is tagged or untagged.
The Port to VLAN screen contains a Port Table with VLAN
parameters for each port. To add a port to or delete a
port from the VLAN, you select the port’s appropriate
configuration options from this table.
VLAN Management > Port to VLAN
Select VLAN Select the ID of the VLAN whose port
membership you are configuring.
Unt No. Select the unit that contains the ports for the
VLAN you are configuring.
For each port in the VLAN, select the appropriate
configuration option:
Tagged The interface is a member of the VLAN. All
packets transmitted by the port will be tagged and will
carry VLAN information.
Untagged The interface is a member of the VLAN. All
packets transmitted by the port will be untagged and
will not carry VLAN information.
Excluded The interface is excluded from the VLAN.
This is the default option.
VLAN Management > VLAN to Port
The VLAN to Port screen displays each port’s VLAN
membership information. It is also used to add a port to or
delete a port from a VLAN.
Unt No. The unit number that contains the ports whose
VLAN information you wish to configure.
Port The number of the port being configured.
Jon VLAN To configure the port’s VLAN membership,
press Jon VLAN to bring up the Join VLAN to Port screen.
VLANs Displays the IDs of the VLANs to which the port
belongs. Each VLAN ID ends with “T” if the port is tagged or
with “U” if the port is untagged in that VLAN.
LAG Displays the LAG to which the port belongs, if any.
If a port belongs to a LAG, it cannot belong to a VLAN.
However, the LAG to which the port belongs can be
configured to belong to a VLAN.
VLAN Management > VLAN to Port
Join VLAN to Port
The Join VLAN to Port screen appears when you click Jon
VLAN in the VLAN to Port screen. You use this screen to
configure the port’s VLAN membership.
•
•
•