Linksys SLM248G4S (G5) - Manual (Page 49)

Chapter  Configuration Using the Web-based Utility
4 24/48-Port 10/100 + 4-Port Ggabt Reslent Clusterng Smart Swtch wth 2 Combo SFPs
Confirm Password Field. Then click Update to save the
changes to the Local Users Table.
Change a user name
Highlight the user name in the Local Users Table. The User
Name, Password, and Confirm Password fields will then be
populated for editing. Modify the user name in the User
Name field, then click Update to update the entry in the
Local Users Table.
Delete a user name
Select the user name from the table, then click Delete.
If you accidentally select the wrong entry in the table, click
Cancel to unselect the highlighted user name.
Click Save Settngs to save the changes, or Cancel
Changes to cancel the changes.
Admin > Static Address
Admin > Static Address
The Static Address screen lets you assign a static address to
a specific Switch interface. A static address is bound to its
assigned interface and cannot be moved. If a static address
is seen on an interface to which it is not assigned, the
address is ignored and is not written to the address table.
A list of all static addresses on the Switch appears at the
bottom of the screen. The top part of the screen contains
the following fields for creating static address entries:
Interface The interface that is associated with the static
address. Select Port or LAG, then select the desired
interface from the accompanying drop-down menu.
MAC Address This is the physical address that is being
mapped to the specified interface.
VLAN ID The VLAN ID number (1-4094) of the configured
VLAN that is associated with the specified interface. If you
use this field the VLAN Name field is disabled.
VLAN Name The name of the VLAN associated with the
specified interface. If you use this field, the VLAN ID field
is disabled.
Status The static address type. The possible values are::
Permanent (Default) Keep the entry permanently.
Delete on Reset Delete the entry when the Switch is
reset.
Delete on Tmeout Delete the entry when a timeout
occurs. The default timeout period is 300 seconds.
Secure The entry is defined for locked ports.
After you have entered the information listed above, click
Add to Lst. The static address will then appear in the list
of static addresses. To delete a static MAC address from
the list, select the entry in the list, then click Delete.
Admin > Dynamic Address
Admin > Dynamic Address
The Dynamic Address screen lets you query the Dynamic
Address Table to find specific dynamic MAC addresses, or
display MAC addresses associated with a specific interface
or VLAN. Query criteria include interface type, MAC
address, VLAN, and table sort key. You can also set the
Dynamic MAC Address Table’s address aging parameter or
clear the table.
Address Agng Specifies the amount of time (in seconds)
that a MAC address remains in the Dynamic MAC Address
table before it times out, if no traffic from the source is
detected. The default value is 00 seconds.
Clear Table If selected, this clears the MAC Address
table.
•
•
•
•