Table7.1 nodes and storage devices – LSI MegaRAID SCSI 320-2 RAID Controller Series 518 User Manual
Page 100
7-6
Installing and Configuring Clusters
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
shows which nodes and storage devices should be powered on
during each step.
Before installing the Cluster Service software you must follow the steps
below:
•
Install Windows 2000 Advanced Server or Windows 2000 Datacenter
Server on each node
•
Set up networks
•
Set up disks
Note:
These steps must be completed on every cluster node
before proceeding with the installation of Cluster Service on
the first node.
To configure the Cluster Service on a Windows 2000-based server, you
must be able to log on as administrator or have administrative
permissions on each node. Each node must be a member server, or
must be a domain controller inside the same domain. A mix of domain
controllers and member servers in a cluster is not acceptable.
Table 7.1
Nodes and Storage Devices
Step
Node 1 Node 2 Storage
Comments
Set Up Networks
On
On
Off
Make sure that power to all storage devices
on the shared bus is turned off. Power on
all nodes.
Set up Shared Disks
On
Off
On
Power down all nodes. Next, power on the
shared storage, then power on the first
node.
Verify Disk Configuration
Off
On
On
Shut down the first node. Power on the
second node.
Configure the First Node
On
Off
On
Shut down all nodes. Power on the first
node.
Configure the Second
Node
On
On
On
Power on the second node after the first
node was successfully configured.
Post-installation
On
On
On
All nodes should be active.