LSI MegaRAID SCSI 320-2 RAID Controller Series 518 - Manual (Page 153)

MegaRAID SCSI 320-2 Hardware Guide IX-1
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Index
Numerics
0 DIMM socket 6-4
160M and Wide SCSI 4-1
68-pin connector pinout for LVD SCSI A-9
68-Pin High Density Connectors A-1
A
AMI Part Number
Battery 6-13
AMPLIMITE .050 Series connectors A-8
Array C-1
Array Configuration Planner 5-15
Array management software C-1
Array performance features 4-5
Array spanning C-1
Assigning Drive Letters 7-15
Assigning RAID levels 5-12
Asynchronous operations C-1
Audible Warnings B-1
Automatic failed drive detection and rebuild 4-6
B
Battery Pack 6-13
BIOS Boot Error Messages 8-3
BIOS Configuration Utility 6-20
BIOS message 6-20
Bus Data Transfer Rate 4-7
Bus Type 4-7
Bus-based 2-11
C
Cable assembly for internal Wide SCSI devices A-2
Cables To Go A-6
Cache Configuration 4-7
Cache I/O C-1
Cache Memory 4-9
Installing 6-4
Card Size 4-7
Changing DRAM Modules 6-15
Changing the Battery Pack 6-15
Channel C-2
Charging the Battery Pack 6-15
Cluster Configuration Wizard 7-16
Cluster Disks
Configuration 7-18
Cluster Installation 7-5
Overview 7-5
Validation 7-25
Cluster Node Network Adapter
Configuration 7-8
Cluster Service
Assigning Drive Letters 7-15
Cluster Node Network Adapter 7-8
Cluster User Account 7-12
Configuring Cluster Disks 7-18
Connectivity and Name Resolution 7-11
Disk Access and Functionality 7-15
Domain Membership 7-12
SCSI Drive Installations 7-27
Setting Up Networks 7-7
Shared Disks Configuration 7-14
Shared Disks Setup 7-13
Software Installation 7-16
Validating the Cluster Installation 7-25
Cluster User Account
Setup 7-12
Clustering
Network Requirements 7-4
Shared Disk Requirements 7-5
Cold swap C-2
Compatibility 4-12
Components 4-8
Configuration on Disk 4-3
Configuration Strategies 5-10
Configuring Arrays 5-9
Configuring Logical Drives 5-13
Configuring SCSI Physical Drives
Distributing Drives 5-1
Configuring SCSI physical drives 5-1
Connecting internal and external Wide devices A-3
Consistency check 2-4
,
C-2
Converting from internal Wide to internal non-Wide (Type 3) A-5
Converting internal Wide to internal non-Wide A-4
Converting internal Wide to internal non-Wide (Type 30) A-5
CPU 4-8
Creating hot spares 5-10
Creating logical drives 5-10
D
Data redundancy
Using mirroring 2-6
Data transfer capacity C-2
Dedicated parity 2-8
Degraded 2-10
,
C-2
Devices per SCSI Channel 4-8
DIMM socket 6-4
DIMMs 6-4