LSI MegaRAID SCSI 320-2 RAID Controller Series 518 - Manual (Page 75)

Installation Steps 6-3
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
6.2.1 Step 1: Unpack
Unpack and install the hardware in a static-free environment. Remove
the MegaRAID SCSI 320-2 controller card from the anti-static bag and
inspect it for damage. If the card appears damaged, or if any item listed
below is missing, contact LSI Logic or your MegaRAID OEM support
representative. The MegaRAID SCSI 320-2 controller is shipped with the
following:
•
The Driver and Documentation CD, which contains these items:
– The MegaRAID Configuration Software Guide
– The MegaRAID Operating System Driver Installation Guide
– The MegaRAID SCSI 320-2 Hardware Guide
– The software license agreement
– The MegaRAID configuration utilities for DOS
•
The warranty registration card
6.2.2 Step 2: Power Down
Turn off the computer, remove the power cord, then remove the cover.
Make sure the computer is turned off and disconnected from any
networks before installing the controller card.
11 Replace the computer cover and turn the
power on. Be sure the SCSI devices
are powered up before, or
at the same time as, the
host computer.
12 Run the MegaRAID BIOS Configuration
Utility. Optional.
13 Install software drivers for the desired
operating systems.
Table 6.1 Hardware Installation Steps (Cont.)
Step Action Additional Information