LG GCC-4480B - Manual (Page 11)

DirectCD TM v2.5b(s) Installation
8
PC Connection
To Install as a
Master Drive
The CD-RW/DVD-ROM drive connects to the motherboard of the host
computer using an IDE interface cable. You may connect the CD-RW/DVD-
ROM Drive as a Slave or Master device, depending on your computer.
NOTE : A hard disk is normally installed as the Primary Master on the
EIDE (ATAPI) interface. Other EIDE peripheral devices such as hard
drives and CD-RW/DVD-ROMs are then set differently.
To install the drive as a Master, the jumper can be left as supplied from
the factory.
DIGITAL ANALOG INTERFACE POWER D R C S M
S L A G L G 39 1 +5 +12 GND 40 2
AUDIO AUDIO
Master drive
(Booting hard disk)
Primary
connector
Secondary
connector
Master drive
(CD-RW/DVD-
ROM drive)
(Jumper left as
MAster)
Motherboard
- OR -
DIGITAL ANALOG INTERFACE POWER D R C S M
S L A G L G 39 1 +5 +12 GND 40 2
AUDIO AUDIO
DIGITAL ANALOG INTERFACE POWER D R C S M
S L A G L G 39 1 +5 +12 GND 40 2
AUDIO AUDIO
Master drive
(Booting hard disk)
Primary
connector
Master drive
(CD-RW/DVD-
ROM drive)
(Jumper left as
MAster)
Slave drive
(Other IDE drive)
Secondary
connector