LG GCC-4480B - Manual (Page 12)

DirectCD TM v2.5b(s) Installation
9
To Install as a
Slave Drive
Connecting
the Power
Connector
To install the drive as a Slave, change the jumper setting on the rear
panel to SL.
DIGITAL ANALOG INTERFACE POWER D R C S M
S L A G L G 39 1 +5 +12 GND 40 2
AUDIO AUDIO
Master drive
(Booting hard disk)
Slave drive
(CD-RW/DVD-ROM
drive)
(Jumper set to
SLave)
DIGITAL ANALOG INTERFA CE POWER D R C S M
S L A G L G 39 1 +5 +12 GND 40 2
AUDIO AUDIO
DIGITAL ANALOG INTERFACE POWER D R C S M
S L A G L G 39 1 +5 +12 GND 40 2
AUDIO AUDIO
Master drive
(Booting hard disk)
Primary connector
Slave drive
(CD-RW/DVD-ROM
drive)
(Jumper set to
SLave)
Secondary
connector
Master drive
(Other IDE drive)
- OR -
Connect the power cable from the computer’s power supply to the socket
on the drive unit, fitting the connector firmly into the power in connector.
If there is no spare power cable available in the computer, you will have
to purchase a splitter cable of a suitable type.
DIGITAL
AUDIO ANALOG
AUDIO INTERFACE
POWER
D G
39
40
1 +5 GND +12
2
C S M
S L A R G L
+5 GND +12
POWER
Beveled edge up
NOTE : Improper connection may damage the drive and void the
warranty. Generally, the power connector can only fit one way.