LG GCC-4480B - Manual (Page 8)

DirectCD TM v2.5b(s) Introduction
5
Front Panel
Rear Panel
Location and Function of Controls
DIGITAL
AUDIO ANALOG
AUDIO
INTERF ACE
POWER
D G
39
40
1 +5 GND +12
2
C S M
S L A R G L
1 2 3 4 5
1. Digital Audio Output Connector
2. Analog Audio Output Connector
3. Jumper Connector
This jumper determines whether the drive is configured as a master or slave.
Changing the master-slave configuration takes effect after power-on reset.
4. IDE Interface Connector
Connect to the IDE (Integrated Device Electronics) Interface using a 40-pin
flat IDE cable.
NOTE : Do not connect or disconnect the cable when the power is on, as this
could cause a short circuit and damage the system. Always turn the power
OFF when connecting or disconnecting the cable.
5. Power Connector
1. Headphone Jack
2. Volume Control
3. Emergency Eject Hole
4. Stop/Eject Button
5. Disc Tray
6. Drive activity indicator (Read/Write)
5
6
1 2 4 3