Memory device error, Network [x] software error, Printer memory full – Lexmark S510 User Manual
Page 134: Printhead cannot move, Printhead error
Memory Device Error
Try one or more of the following:
•
Remove the memory device, and then reinsert it into the card slot or USB port.
•
Touch OK or press
to clear the message.
Network [x] Software Error
[x] is the number of the network connection.
Try one or more of the following:
•
Press
to clear the message.
•
Turn the printer off and then back on to reset the printer.
Printer Memory Full
Try one or more of the following:
•
Depending on your printer model, touch OK or press
to clear the message, and then try printing again.
•
From the computer, adjust the printer settings to reduce the quality of the print job, and then try printing again.
Printhead Cannot Move
Try one or more of the following:
•
Open the printer to remove any obstructions to the printhead, and then close the printer.
•
Press
to clear the message.
Printhead Error
Remove and reinsert the printhead
Warning—Potential Damage: Do not touch the cartridge contacts with bare hands to avoid damage and print
quality problems.
1
Open the printer, and then lift the latch.
Troubleshooting
134