Receiving faxes automatically, Receiving faxes manually – Lexmark S510 User Manual
Page 84
Receiving faxes automatically
1
Make sure that Auto Answer is on:
From the printer control panel, navigate to:
> Setup >
> Fax Setup >
> Ringing and Answering >
> Auto Answer >
> On >
2
Set the number of rings before the printer picks up incoming faxes:
a
Press the arrow buttons to scroll to Pick Up On, and then press
.
b
Press the arrow buttons to scroll to the number of rings that you want, and then press
to save the setting.
When the number of rings you set is detected, the printer automatically receives the incoming fax.
Warning—Potential Damage: Do not touch the cables or the and
ports while actively receiving a fax.
Tips:
•
If the printer is sharing the line with other analog devices (telephone, answering machine), then set the printer to
pick up calls two rings after the answering machine. For example, if the answering machine picks up calls after four
rings, then set the printer to pick up after six rings. This way, the answering machine picks up calls first and your
voice calls are received. If the call is a fax, then the printer detects the fax signal on the line and takes over the call.
If the printer is on a dedicated fax line, then you may set the printer to pick up on any number of rings.
•
If you have multiple numbers on a single line, or if you subscribe to a distinctive ring service provided by your
telephone company, then make sure that you set the correct ring pattern for the printer. Otherwise, the printer
will not receive faxes even if you have set it to receive faxes automatically.
Receiving faxes manually
1
Turn off Auto Answer:
From the printer control panel, navigate to:
> Setup >
> Fax Setup >
> Ringing and Answering >
> Auto Answer >
> Off >
2
When the telephone rings and you hear fax tones when you pick up the handset, press
on the printer or *9* on
the telephone attached to the printer.
Warning—Potential Damage: Do not touch the cables or the and
ports while actively receiving a fax.
Tips:
•
The default code for answering faxes manually is *9*, but for increased security, you can change it to a number
that only you know. You can enter up to 7 characters for your code. The valid characters are the digits 0–9 and the
characters # and *.
•
Make sure that the telephone is plugged into the
port on the back of the printer and that the printer is connected
to the wall jack through the port.
Faxing
84