Lenovo 1047 - Manual (Page 54)

4. Remove the system board battery.
Figure 31. Removing the system board battery
5. Dispose of the battery as required by local ordinances or regulations.
What to do next:
• To install a new system board battery, see “Installing the system board battery” on page 42.
• To work with another piece of hardware, go to the appropriate section.
Installing the system board battery
Attention: Do not open your server or attempt any repair before reading and understanding the “Safety information”
on page iii and “Guidelines” on page 19.
This section provides instructions on how to install the system board battery.
Be sure to consider the following information when you replace the battery in the server:
• You must replace the battery with a lithium battery of the same type from the same manufacturer.
• After you replace the system board battery, you must reconfigure the server and reset the system date
and time.
• To avoid possible danger, read and follow the following safety statement.
Statement 2
DANGER
Danger of explosion if battery is incorrectly replaced.
When replacing the lithium coin cell battery, use only the same or an equivalent type that is
recommended by the manufacturer. The battery contains lithium and can explode if not properly
used, handled, or disposed of.
Do not:
• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the system board battery, do the following:
Note: Follow any special handling and installation instructions that come with the replacement battery.
42 ThinkServer User Guide