Lenovo 1047 - Manual (Page 92)

Table 17. Submenus under the Hardware Health Configuration
Item Option Description
Items and options with BMC configuration:
Auto Fan Control Disabled / [Enabled] If this option is set to Disabled, the
fan runs at the full speed; if this option
is set to Enabled, the fan speed is
controlled by the system temperature.
PWM Minimal Duty Cycle [60% Duty Cycle] / 45% Duty Cycle
/ 30% Duty Cycle Select the PWM Minimal Duty Cycle
for the fan: 60%-100%, 45%-100%,
or 30%-100%.
Sensor Data Register Monitoring Read Only The sensor data in this option is for
read only. The detected data includes
the temperature, voltage and fan
speed.
Items and options without BMC configuration:
H/W Health Function Disabled / [Enabled] Enable or disable the hardware
monitor function.
Auto FAN Control Disabled / [Enabled] If this option is set to Disabled, the
fan runs at the full speed; if this option
is set to Enabled, the fan speed is
controlled by the system temperature.
PWM Minimal Duty Cycle [60% Duty Cycle] / 45% Duty Cycle
/ 30% Duty Cycle Select the PWM Minimal Duty Cycle
for the fan: 60%-100%, 45%-100%,
or 30%-100%.
Fan Failure LED Indication Disabled / [Enabled] Enable or disable the fan alarm
function. If this option is set to
Enabled, a message about fan failure
will be displayed on the POST screen
when the rotational speed of each fan
is less than 800 rpm.
Hardware Health Event Monitoring Read Only The sensor data in this option is for
read only. The detected data includes
the temperature and system fan
rotational speed.
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 18. Submenus under the IPMI 2.0 Configuration
Item Sub-item Option Description
View BMC System Event
Log View the system event log.
Clear BMC System Event
Log Delete the system event
log.
Set LAN Configuration Set the IP address source,
IP address, subnet mask,
and gateway address.
Set PEF Configuration PEF SUPPORT Disabled / [Enabled] Enable or disable the PEF
support.
80 ThinkServer User Guide