Lenovo 1047 User Manual
Page 64
Figure 44. Installing the RAID controller into the PCI card slot 1 on the riser card assembly
Note: There are three PCI card slots on the riser card assembly as shown in the illustration. The PCI
card slot 1
2
is for RAID cards only. For more information about the PCI card slots, see “Installing a
8. Install the riser card assembly with the RAID controller into an appropriate PCI card slot on the system
board.
9. Connect the other end of the two 400 mm (15.75 inches) mini SAS signal cables to the backplane of
your server.
Figure 45. Mini SAS signal connectors on the backplane
a. For one mini SAS signal cable, connect the other end to the mini SAS signal connector
2
on the
backplane.
b. For the other SAS signal cable, connect the other end to the mini SAS signal connector
1
on the
backplane.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 71.
52
ThinkServer User Guide