Lenovo 1047 User Manual
Page 59
c. Hold the battery card assembly with the battery side up and the J2 board-to-board connector lining
up with the J7 BBU connector
1
on the RAID controller. Carefully press the battery card assembly
onto the RAID controller so that the two connectors are firmly joined. Then, secure the battery
card assembly to the RAID controller with the three screws and the standoffs that come with the
battery card assembly accessory kit.
Figure 36. Installing the battery card assembly
1
J7 BBU connector
5. Position the RAID controller near the riser card assembly. Ensure that the left edge of the RAID controller
is inserted into the notch of the RAID card retention bracket
1
, and then firmly insert the RAID controller
straight down into the PCI card slot 1
2
until it is securely seated. Then install the screw
3
to secure the
RAID controller.
Figure 37. Installing the RAID controller into the PCI card slot 1 on the riser card assembly
Note: There are three PCI card slots on the riser card assembly as shown in the illustration. The PCI
card slot 1
2
is for RAID cards only. For more information about the PCI card slots, see “Installing a
Chapter 5
.
Installing, removing, or replacing hardware
47