Lenovo 1047 - Manual (Page 50)

This section provides instructions on how to install the riser card assembly. The riser card assembly might
have PCI card(s) installed on it.
To install the riser card assembly, do the following:
Note: Use any documentation that comes with the riser card assembly and follow those instructions in
addition to the instructions in this section.
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 21.
3. Touch the static-protective package that contains the riser card assembly to any unpainted metal
surface on the server. Then, remove the riser card assembly from the static-protective package.
4. Position the riser card assembly in place so that you can press the riser card assembly straight down
into the PCI card slot on the system board. See “Locating parts on the system board” on page 16.
Then, install the two screws to secure the riser card assembly in place. You might need a screw driver to
make sure that the screws are firmly tightened and the riser card assembly is securely installed. Do
not over-tighten the screws.
Note: You might need to press the retaining latch of the slot to secure the riser card assembly into
the slot.
Figure 27. Installing the riser card assembly
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 71.
Installing or removing a PCI card
This section provides instructions on how to install or remove a PCI card.
38 ThinkServer User Guide