Lexmark 4098-001 - Manual (Page 37)

Repair Information 4-3
4098-001
Auto Compensator Assembly Removal
1. Remove all covers.
2. Remove the E-clip from right side of the auto compensator
shaft.
Note: For reinstalling purposes, note the position of the spring
before removing.
3. Pull shaft out the left side and remove auto compensator.
Buttons / Lenses Removal
1. Remove all covers.
2. Remove operator panel.
3. Depress the button clips and remove the buttons.
4. Lift and remove the lenses.
Carrier Frame Assembly / Base Removal
1. Remove all covers.
2. Remove the three screws that secure the carrier frame to the
base assembly.
3. Remove system board cable.
4. Pull frame to the rear and remove. Note routing of ground
cables.