Printhead cable and cradle removal, Rear cover removal – Lexmark 4098-001 User Manual
Page 42
Advertising
4-8
Service Manual
4098-001
Printhead Cable and Cradle Removal
1. Remove all covers.
2. Remove the printhead carrier assembly.
3. Disconnect the printhead cable from the encoder card. Note the
routing of the cable under the retaining clip on the carrier.
4. Separate the cradle from the printhead carrier assembly by
pushing out the cradle latches {A}.
Rear Cover Removal
1. Remove the two screws from rear cover.
2. Insert screwdriver and depress two plastic latches and remove
rear cover.
Advertising