Erasing personal code, Anti-scan feature, Locks and security – Lincoln 2011 MKX User Manual

Page 111

Advertising
background image

Tips:
• Do not set a code that uses five of the same number.
• Do not use five numbers in sequential order.
• The factory set code will work even if you have set your own personal

code.

Erasing personal code

1. Enter the factory set 5–digit code.

2. Within five seconds, press the 1

• 2 on the keypad and release.

3. Press and hold the 1

• 2 for two seconds. This must be done within

five seconds of completing Step 2.

All personal codes are now erased and only the factory set 5–digit code
will work.

Anti-scan feature

If the wrong code has been entered seven times (35 consecutive button
presses), the keypad will go into an anti-scan mode. This mode disables
the keypad for one minute and the keypad lamp will flash.

The anti-scan feature will turn off after:
• one minute of keypad inactivity.
• pressing the

control on the remote entry transmitter portion of

your integrated keyhead transmitter.

• the ignition is turned on.

Unlocking and locking the doors using keyless entry

To unlock the driver’s door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate. Note: If the two-stage unlocking
feature is disabled, all doors will unlock; for more information regarding
two-stage unlocking, refer to the Unlocking the doors/Two stage unlock
section earlier in this chapter.

To unlock all doors, enter the factory set code or your personal code,
then press the 3

• 4 control within five seconds.

To lock all doors, press and hold the 7

• 8 and the 9 • 0 at the same

time (with the driver’s door closed). You do not need to enter the
keypad code first.

Locks and Security

111

2011 MKX (mkx)
Owners Guide, 1st Printing
USA
(fus)

Advertising