Seating and safety restraints – Lincoln 2011 MKX User Manual

Page 164

Advertising
background image

position whenever possible. If all children cannot be seated and
restrained properly in a rear seating position, properly restrain the
largest child in the front seat.

When installing a child safety seat with combination lap/shoulder belts:
• Use the correct safety belt buckle for that seating position.
• Insert the belt tongue into the proper buckle until you hear a snap

and feel it latch. Make sure the tongue is securely fastened in the
buckle.

• Keep the buckle release button pointing up and away from the safety

seat, with the tongue between the child seat and the release button,
to help prevent accidental unbuckling.

• Place vehicle seat back in upright position.
• Put the safety belt in the automatic locking mode. Refer to Step 5

below. This vehicle does not require the use of a locking clip.

WARNING: Depending on where you secure a child restraint,
and depending on the child restraint design, you may block

access to certain safety belt buckle assemblies and/or LATCH lower
anchors, rendering those features potentially unusable. To avoid risk of
injury, occupants should only use seating positions where they are able
to be properly restrained.

Perform the following steps when installing the child seat with
combination lap/shoulder belts:

Note: Although the child seat illustrated is a forward facing child seat,
the steps are the same for installing a rear facing child seat.

1. Position the child safety seat in a
seat with a combination lap and
shoulder belt.

Seating and Safety Restraints

164

2011 MKX (mkx)
Owners Guide, 1st Printing
USA
(fus)

Advertising