Driver controls – Lincoln 2011 MKX User Manual

Page 85

Advertising
background image

Note: Cycling the ignition prior to completely latching the liftgate could
result in damage to the liftgate and/or its power components. Make sure
the liftgate is fully latched before operating the vehicle.

Care should be exercised in starting the engine before the liftgate is fully
closed (latched). If the ignition is cycled during a liftgate power close
cycle and the liftgate is 6–10 inches (15–24 cm) from being latched, the
liftgate may reverse to the full open position. Verify that the gate is
closed before operating or moving the vehicle, especially in an enclosure,
like a garage or a parking structure. The liftgate or its components could
be damaged in an enclosure if the liftgate is open while the vehicle is
being operated.

When power operating the liftgate at temperatures below 32°F (0°C), the
liftgate may stop about 5 inches (12.7 cm) from the full open position.
The liftgate can be fully opened by pushing it upward to the maximum
open position.

The power liftgate feature can be enabled or disabled using the message
center controls. With the setting turned off, power operation is disabled
from the liftgate handle button and from the rear cargo area button. The
transmitter and instrument panel switch will still continue to operate the
liftgate regardless of the position state of the message center. Refer to
Message center in the Instrument Cluster chapter.

To power open or close the
liftgate from the instrument
panel:

Press the button, located to the left
of the steering column, once to
power open or close the liftgate.

To power open or close the liftgate with the transmitter:

Press

twice within three seconds to power open or close the liftgate.

Refer to Remote entry system in the Locks and Security chapter.

Driver Controls

85

2011 MKX (mkx)
Owners Guide, 1st Printing
USA
(fus)

Advertising