Seating and safety restraints – Lincoln 2011 MKX User Manual

Page 170

Advertising
background image

The rear seats of your vehicle are equipped with built-in tether strap
anchors located behind the seats as described below.

The tether anchors in your vehicle are located under the second row
seat gap cover marked with tether anchor symbols (shown with title).

The tether strap anchors in your
vehicle are in the following positions
(shown from top view):

WARNING: Attach the tether strap only to the appropriate
tether anchor as shown. The tether strap may not work properly

if attached somewhere other than the correct tether anchor.

WARNING: Do not use seat anchors as cargo tie downs.

Once the child safety seat has been installed, using either the safety belt,
the lower anchors of the LATCH system, or both, you can attach the top
tether strap.

If you install a child seat with rigid LATCH attachments, and have
attached the top tether strap to the proper top tether anchor, do not
tighten the tether strap enough to lift the child seat off the vehicle seat
cushion when the child is seated in it. Keep the tether strap just snug
without lifting the front of the child seat. Keeping the child seat just
touching the vehicle seat gives the best protection in a severe crash.

Perform the following steps to attach a child safety seat to the tether
anchor:

1. Route the child safety seat tether strap over the back of the seat.

For vehicles with adjustable head restraints, route the tether strap under
the head restraint and between the head restraint posts, , otherwise
route the tether strap over the top of the head restraint. If the top of the
safety seat hits the adjustable head restraint, raise the head restraint to
let the child seat fit further rearward.

Seating and Safety Restraints

170

2011 MKX (mkx)
Owners Guide, 1st Printing
USA
(fus)

Advertising