Polaris 600 EDGE Touring 121 - Manual (Page 135)

132
MAINTENANCE
Battery
Battery Connections
Keep battery terminals and connections free of corrosion. When
cleaning is necessary, remove the corrosion with a stiff wire brush.
Wash terminals and connections with a solution of one tablespoon
baking soda and one cup water. Rinse well with tap water and dry with
clean shop towels. Coat the terminals with dielectric grease or
petroleum jelly.
CAUTION
Tap water contains minerals that will damage a battery and
shorten its life. Use only distilled water to refill your battery.
Never allow cleaning solution or tap water to enter the battery.
Battery Removal
WARNING
Improperly connecting or disconnecting battery cables can result
in an explosion and cause serious injury or death. When
removing the battery, always disconnect the negative (black)
cable first. When reinstalling the battery, always connect the
negative (black) cable last.
1. Disconnect battery hold down straps.
2. Remove battery vent tube from battery.
3. Disconnect black (negative) battery cable first.
4. Disconnect red (positive) battery cable second.
5. Carefully lift the battery out of the snowmobile. Do not tip it
sideways or spill electrolyte.
CAUTION
If electrolyte spills, immediately wash it off with a solution of one
tablespoon baking soda and one cup water to prevent damage to
the vehicle.