Polaris 600 EDGE Touring 121 - Manual (Page 143)

140
TROUBLESHOOTING
M-10 ACE Suspension Troubleshooting
Problem Solution (perform only one change at a time)
Rear suspension
bottoms too easily
- Increase M-10 ACE position (see setup decal under hood for
initial position)
- Increase rear track shock coil spring preload
- Revalve rear track shock compression damping
(see your dealer)
- Check track tension
Rides too stiff in
rear
- Decrease M-10 ACE position (see setup decal under hood)
- Decrease rear track shock spring preload collar spacing
- Revalve rear track shock compression damping
(see your dealer)
- Check track tension
Machine darts from
side to side
- Make sure skis are aligned properly
- Make sure spindles and all steering components turn freely
- Make sure skags are straight on skis
- Increase IFS preload
- Ensure use of Accu-Trakt dual skags
Front end pushes - Check for worn skags
- Check for binding suspension shafts and grease all pivot points
- Increase front IFS preload
- Shorten front limiter strap
Steering is heavy - Check ski alignment
- Check skags and skis for damage
- Decrease IFS preload
- Make sure spindles and all suspension components turn freely