Polaris 600 EDGE Touring 121 - Manual (Page 136)

133
MAINTENANCE
Battery
Battery Installation
WARNING
Batteries contain gases that can explode. If the battery vent tube
is pinched or kinked, battery gases could accumulate. Whenever
removing or installing the battery, disconnect the negative (black)
cable first and reinstall the negative cable last to avoid the
possibility of explosion.
Battery electrolyte contains acid. Avoid skin contact with
electrolyte as severe burns may result.
1. Place the battery in its holder. Attach the hold down strap.
2. Install the battery vent line. It must be free from obstructions and
securely installed. Route the vent line properly to prevent kinks and to
allow for proper drainage.
3. Connect and tighten the red (positive) cable first.
4. Connect and tighten the black (negative) cable last.
5. Verify that cables and vent hose are properly routed.
Battery Storage
When your snowmobile is placed in storage for one month or more:
S
Remove the battery.
S
Charge it to the proper level.
S
Store it in a cool dry place.
S
Check and/or charge monthly.
Before using the battery, take it to your dealer for testing and
recharging.
Batteries may freeze if not fully charged, resulting in cell damage.
Charge Condition: Will Freeze At:
100% -75° F (-59° C)
75% -24° F (-31° C)
50% 0° F (-18° C)
25% +13° F (-11° C)
0% +18° F (-8° C)