Adding additional cards and/or updating drivers, Adding at host cards to the system – Perle Systems Adaptors User Manual
Page 31
FAST Serial Adaptors User Guide
Installing under Windows 2000/XP/Server 2003/Vista/Server 2008
Page 31
Chapter 2 Installing drivers and host cards
Adding additional cards and/or updating drivers
Whenever you add any additional FAST hardware to your system, Windows might install the
latest digitally signed driver in its database (depending on your Windows operating system
and settings). To ensure you have the latest driver installed after you add new hardware, you
can either:
•
Click
Start > All Programs > Perle > Perle-Serial > Update Driver
or
•
Reinstall the drivers as described in
Installing device drivers and utilities onto your
.
Adding AT host cards to the system
When you physically install an AT host card in your system you also need to add the card to
the list of installed devices in the system.
To add AT host cards to your system proceed as follows:
1. In the Windows desktop, click on the
Start
button and select
Settings > Control Panel
The control panel window is now displayed.
2. In the control panel window, double click on the
System
icon.
The Add/Remove Hardware Wizard is now displayed.
Note
The addresses used by AT-FAST host cards are normally set by
default. This procedure is used when you wish to set non-standard
addresses.