Perle Systems Adaptors - Manual (Page 66)

FAST Serial Adaptors User Guide
Installing under SCO UnixWare
Page 66
Chapter 2 Installing drivers and host cards
General setup procedure for SCO UnixWare
The general procedure for installing FAST cards under the SCO UnixWare operating system
is as follows;
1. Before commencing the installation process under SCO UnixWare, configure your system
as described in Initial configuration under SCO UnixWare on page 67 .
2. Install any PCI host cards and distribution cables or boxes you require into your system.
See Installing host cards and distribution accessories on page 79 .
3. Install any AT cards and distribution cables or boxes you require into your system. See
Installing host cards and distribution accessories on page 79 .
4. Install the driver software ionto your system using the procedures given in Installing SCO
UnixWare drivers using command line on page 68 or Installing SCO UnixWare
drivers using the Desktop on page 70
5. You can then enable login access using the procedures given in Enabling login
access on page 70 .
6. If required, remove any host cards you want from your system. See Removing host
cards on page 103 .
Note
If you are installing AT-FAST hardware you should examine your system
configuration and determine non-conflicting I/O addresses and IRQs for use with
each ISA card.
Note
For information on upgrading or re-installing drivers, see
Reinstalling or
upgrading software on page 70 .
To remove drivers, see Removing the driver software on page 50
For information on installing additional cards see Installing additional cards on
page 70 .