Perle Systems Adaptors - Manual (Page 53)

FAST Serial Adaptors User Guide
Installing under SCO OpenServer 6
Page 53
Chapter 2 Installing drivers and host cards
General installation procedure for SCO OpenServer 6
The general procedure for installing and configuring host cards, drivers software and
associated utilities for the SCO OpenServer 6 operating system is as follows:
1. Install any AT-FAST cards you require into your system. See Installing host cards and
distribution accessories on page 79
2. Install the SPEED SCO OpenServer 6 drivers and utilities onto your system using the
procedures described in Installing device drivers and utilities on page 54 .
3. If required, remove any host cards you want from your system. See Removing host
cards on page 103 .
4. Using the Port Configuration tool , configure the serial ports you have added to the
system. See Configuring serial ports on page 60 .
Your system can now use the serial adaptor cards you have installed. If required, you can
reconfigure serial ports following initial installation.