Panasonic DX-800 - Manual (Page 92)

Sending Documents via LAN
92
NOTE 1. If your machine sounds an alarm (pi-pi-pi) in Step 2 above, this indicates that the Dialer is Full
(more than 70 full email addresses are entered or 70 transmission reservations including G3
communication have been already reserved).
2. If the transmission cannot be completed for any reason, the email may be returned
undelivered; otherwise no reply will be printed.
3. For the machine to perform the email address completion the Fax Parameter No. 160
(DEFAULT DOMAIN) must be set to "Valid" and the DEFAULT DOMAIN must be
preprogrammed in the User (Internet) Parameters. (See page 49)
Manual Email Addressing
1
Set document(s) face down.
ENTER STATION(S)
THEN PRESS START 00%
2
To choose Manual Email Addressing mode.
❚
ENTER EMAIL ADDRESS
3a
Enter the full email address using the Character keys (up
to 60 characters).
Ex:
If you make a mistake, press to erase the character
then re-enter the correct character.
[email protected]
3b
Enter the User portion of the email address and press
. The machine will complete the email address
with the Default Domain preprogrammed in the User
(Internet) Parameters. (i.e. will add "panasonic.com" to
the email address)
abc
3c
If you want to send to a different Domain, enter the first
part of an email address, press and use the
or key to display domain names in the Selectable
Domains List. Choose the desired domain and press
. (See Note 3 and page 100)
[email protected]
4
The document(s) is stored into memory with a file number.
Then connects to the LAN and starts sending the email
message.
* STORE * NO.001
PAGES=001 01%
* STORE * COMPLETED
TOTAL PAGE=005 25%
ON LINE * MEM.MXT *
ID:[email protected]
EMAIL
a b c p a n a s o n i c
c o m
CLEAR
SET
START